Application
PC series grinding is applied to the intermediate crushing and fine crushing of materials in metallurgy, mining, chemical, cement, coal, sand-making, coal gangue, construction, refractory materials and ceramic industries.
Mainly for the comprehensive strength of materials should be not higher than 320 MPA.
Features
High manufacturing capacity and low power consumption
Uniform particle size with high crushing ratio
Simple structure
Easy operation and low investment
Working principle
PC series grinding is mainly consists of frame, rotor, support iron and grate bars.
1. The frame is divided into two parts: Upper part and lower part, which are welded after being cut by steel plates. There is high manganese steels inside it, which is replaceable.
2. Rotor consists of the main shaft with several regularly grouped hammers, turn plate, pin shaft. Through the motor and triangle belts, the main unit drives the main shaft, and thereby drives the rotor.
3. Large materials entering the crusher through the feed inlet are firstly crushed by the high-speed hammers, and then the materials will be threw fiercely to the support iron, at this time, the materials will be crushed again.
4. The qualified materials will be screened out and exit from the gap of the Grate bars, then what about the unqualified? They will be left in the crushing cavity to be further hammered and ground until reach the standard size.
Type |
PC4008-75 |
PC4012-90 |
PC4015-132 |
Rotor Diameter/mm |
750 |
900 |
1150 |
Rotor Width/mm |
800 |
1200 |
1500 |
Rotor Speed/ ( r/min) |
800-1000 |
800-1000 |
550-800 |
Max Feeding Size/mm |
<70 |
<90 |
<100 |
Finished Particle Size/mm |
≤3 |
≤3 |
≤3 |
Capacity/( t/h) |
35-50 |
50-70 |
70-100 |
Power/KW |
55-75 |
75-90 |
110-132 |
Hammer Number |
18 |
16 |
32 |
Layout Size(L*W*H/mm) |
2310*1665*1610 |
2840*2100*2020 |
3720*2650*2540 |